Open Element Air Cleaner Tip

When installing an open-element air cleaner, use a drop-base unit. This will allow for additional hood clearance, and it opens up the possibility of using a larger filter element.

Rear Disc Brake Tip

While many folks are content with slapping on a new set of front discs, very few people take the time to do it right and upgrade the rear as well. There’s a host of reasons to pitch out those old shoes and slap on a set of rotors, the obvious one being vastly superior braking […]

Wet Sanding Tip

Wet sanding your car’s paint finish isn’t as scary as it seems. Choose an open, outdoor area that will allow you to run water continuously for extended periods of time. Use 1000-2500 grit fine sandpaper (depending on the severity of the paint imperfections), garden hose or bucket, clean rags. The actual task of wet sanding […]

Carpet Flattening Tip

After purchasing a new carpet kit, remove the pieces from the box and lay them out flat. This will help take the folds and creases of packaging out of the rug before it goes into the car. If the weather permits, lay the carpet outside in the direct sun with the plastic backing facing up- […]

Water Pump and Coolant Tip

When installing a new water pump, or after flushing out your system, never reuse old coolant. Over time it can chemically break down and actually harm and attack the internals of your cooling system.           Also: Old gasket removal is highly critical to obtaining a good, leak-free seal. Using a putty […]

Weatherstripping Tip

If you happen to break or lose a plastic retainer during installation, try using 3M weatherstrip adhesive in its place. The glue is super tacky and forms a lasting, watertight seal. http://www.rickscamaros.com/weatherstrip-adhesive-super-black-3m-1.html

Flywheel and Flexplate Tip

Be sure to research the right replacement part for your application. An improperly balanced rotating assembly will wreak havoc on the rest of your motor. In addition to the flywheel and flexplate, you’ll need a new ring gear plate, flywheel/flex plate bolts (optional), Loctite. New GM flywheels can be purchased from Eckler’s. It’s a good […]

Engine Removal Tip

Engine removal: If you’re renting an engine hoist, remember you’ll also need a heavy-duty chain and/or lifting plate. If you pull the motor and transmission out together as one unit, invest in a transmission tail plug to avoid trans fluid from pouring out the rear of the case during removal.

Steering Column Wiring Harness Tip

When removing the old switch from the column, tie a piece of string or twine to the end of the connector. This can be used to feed and guide the new harness down through the shaft cover.

Battery Safety Tip

To get started replacing your old battery, make sure you also buy new cables, a wire brush, and terminal ends (optional). Always remove the negative battery cable from the terminal post before the positive. Any sparks from or around the terminals could ignite battery gasses and cause personal injury. In addition to having a clean battery and fresh […]

Optin Architect