If you plan on removing your crankshaft while leaving the rod and piston assemblies in the bores, attach a rubber band to a bolt on each rod and to a reinstalled oil pan bolt. This will keep the rods off to the side and from banging into the block when pulling the crank out.
Coil Spring Removal Tip
August 22, 2014 by Leave a Comment
If you’re going to be removing your car’s original coil springs, you’re going to need to support the lower control arm. This can be done with a heavy block of wood and whatever further support is available (jackscrew, etc). Remember, the spring is under great pressure, and once the spindle assembly is removed, the spring […]
Stone Chip Clean-Up Tip
July 11, 2014 by Leave a Comment
First, make sure the area you’re working on is free from wax or dirt. Use rubbing alcohol to clean the chipped area. Never use the brush that comes with the touch-up paint– it will just cause big, nasty globs and end up looking worse than the chip. Use a small artist’s grade brush and gently […]
Wet Sanding Tip
April 25, 2014 by Leave a Comment
Wet sanding your car’s paint finish isn’t as scary as it seems. Choose an open, outdoor area that will allow you to run water continuously for extended periods of time. Use 1000-2500 grit fine sandpaper (depending on the severity of the paint imperfections), garden hose or bucket, clean rags. The actual task of wet sanding […]
Water Pump and Coolant Tip
April 11, 2014 by Leave a Comment
When installing a new water pump, or after flushing out your system, never reuse old coolant. Over time it can chemically break down and actually harm and attack the internals of your cooling system. Also: Old gasket removal is highly critical to obtaining a good, leak-free seal. Using a putty […]
Chevrolet Performance Rewards Loyal NHRA Racers
March 6, 2014 by Leave a Comment
Chevrolet Performance, the high-performance parts division of Chevrolet, has announced that it will increase its contingency payouts to those who race in NHRA-sanctioned events using Chevrolet Performance parts while displaying the brand’s decals. Says Jim Campbell, General Motors U.S. Vice President of Performance Vehicles and Motorsports, “Chevrolet has a long history of supporting NHRA drag racers […]
